Upgrading MMC client to Exchange 2010

This is a short guide on upgrading MMC client from Microsoft Exchange 2007 to Microsoft Exchange 2010. Instructions from start to finish.

Upgrading MMC client from MS Exchange 2007 to MS Exchange 2010

Step 1

Uninstall Exchange 2007 from programs.  (uncheck Management Tools)

Step 2

Restart your computer.

Step 3

Install Exchange 2010, selecting only the Management Tools. Run setup.exe located in the Exchange 2010 installer ISO. Click next until it begins the installation.

Exchange 2010 MMC

Step 4

The install will error out and say to restart. After restarting run setup again.

exchange2010 - configuring

Step 5

You will be asked if you want to use your previous settings. If you select yes you will get past the error.

exchange2010 resume setup

Step 6

Open MMC and click “File>Add/Remove Snap-in…”

MMC Add/Remove Snap-in

Step 7

Then go add the Snap-in to MMC for Exchange 2010 and remove the old Exchange 2007 Snap-in.

Snap-in for Exchange 2010

Recommended Reference Books

Microsoft Exchange Server 2010 Best Practices

You may also like:

Installing Active Directory Snap-in on Windows 10 One of the main Active Directory domain management tools is the MMC snap-in Active Directory Users and Computers (ADUC). To work with ADUC snap-in in ...
Open Windows Services on Remote Computer Maybe remote desktop is not available or perhaps you just want to check or restart a windows service on a remote computer. Follow the steps below to o...
Configure MMC Snap-ins on Fresh Windows 7 Install This is a tutorial on configuring the Microsoft Management Console from scratch after a fresh install of Windows 7. This includes setting up the Act...
Disconnected User Mailbox or Room Mailbox Not Show... Ran across a problem after disabling a room mailbox, it didn't show up in the Exchange Management Console. This applies to both User Mailboxes and Roo...
READ ALSO  Configure Data Deduplication on Windows Server 2012 R2